smartctl 7.3 2022-02-28 r5338 [FreeBSD 13.1-RELEASE-p2 amd64] (local build) Copyright (C) 2002-22, Bruce Allen, Christian Franke, www.smartmontools.org === START OF INFORMATION SECTION === Model Family: Seagate Momentus 5400.2 Device Model: ST96812AS Serial Number: -- Firmware Version: 7.24 User Capacity: 60,022,480,896 bytes [60.0 GB] Sector Size: 512 bytes logical/physical Device is: In smartctl database 7.3/5319 ATA Version is: ATA/ATAPI-7 (minor revision not indicated) Local Time is: Sat Oct 22 06:21:16 2022 CEST SMART support is: Available - device has SMART capability. SMART support is: Enabled AAM feature is: Unavailable APM level is: 128 (minimum power consumption without standby) Rd look-ahead is: Enabled Write cache is: Enabled DSN feature is: Unavailable ATA Security is: Disabled, NOT FROZEN [SEC1] Wt Cache Reorder: Unavailable === START OF READ SMART DATA SECTION === SMART overall-health self-assessment test result: PASSED See vendor-specific Attribute list for marginal Attributes. General SMART Values: Offline data collection status: (0x82) Offline data collection activity was completed without error. Auto Offline Data Collection: Enabled. Self-test execution status: ( 0) The previous self-test routine completed without error or no self-test has ever been run. Total time to complete Offline data collection: ( 426) seconds. Offline data collection capabilities: (0x5b) SMART execute Offline immediate. Auto Offline data collection on/off support. Suspend Offline collection upon new command. Offline surface scan supported. Self-test supported. No Conveyance Self-test supported. Selective Self-test supported. SMART capabilities: (0x0003) Saves SMART data before entering power-saving mode. Supports SMART auto save timer. Error logging capability: (0x01) Error logging supported. No General Purpose Logging support. Short self-test routine recommended polling time: ( 2) minutes. Extended self-test routine recommended polling time: ( 32) minutes. SCT capabilities: (0x0001) SCT Status supported. SMART Attributes Data Structure revision number: 10 Vendor Specific SMART Attributes with Thresholds: ID# ATTRIBUTE_NAME FLAGS VALUE WORST THRESH FAIL RAW_VALUE 1 Raw_Read_Error_Rate POSR-- 106 091 006 - 11062340 3 Spin_Up_Time -O---- 097 097 000 - 0 4 Start_Stop_Count PO--CK 095 095 020 - 5202 5 Reallocated_Sector_Ct PO--CK 100 100 036 - 0 7 Seek_Error_Rate POSR-- 084 060 030 - 322129150 9 Power_On_Hours -O--CK 089 089 000 - 10367 10 Spin_Retry_Count PO--C- 100 100 034 - 0 12 Power_Cycle_Count PO--CK 097 097 020 - 3702 187 Reported_Uncorrect -O--CK 060 060 000 - 40 189 High_Fly_Writes -O-RCK 001 001 000 - 478 190 Airflow_Temperature_Cel -O---K 068 044 045 Past 32 (Min/Max 24/33) 192 Power-Off_Retract_Count -O--CK 100 100 000 - 325 193 Load_Cycle_Count -O--CK 005 005 000 - 190651 194 Temperature_Celsius -O---K 032 056 000 - 32 195 Hardware_ECC_Recovered -O-RC- 063 046 000 - 131912915 197 Current_Pending_Sector -O--C- 100 100 000 - 0 198 Offline_Uncorrectable ----C- 100 100 000 - 0 199 UDMA_CRC_Error_Count -OSRCK 200 200 000 - 0 200 Multi_Zone_Error_Rate ------ 100 253 000 - 0 202 Data_Address_Mark_Errs ------ 100 253 000 - 0 ||||||_ K auto-keep |||||__ C event count ||||___ R error rate |||____ S speed/performance ||_____ O updated online |______ P prefailure warning General Purpose Log Directory not supported SMART Log Directory Version 1 [multi-sector log support] Address Access R/W Size Description 0x00 SL R/O 1 Log Directory 0x01 SL R/O 1 Summary SMART error log 0x02 SL R/O 5 Comprehensive SMART error log 0x03 SL R/O 5 Ext. Comprehensive SMART error log 0x06 SL R/O 1 SMART self-test log 0x07 SL R/O 1 Extended self-test log 0x09 SL R/W 1 Selective self-test log 0x10 SL R/O 1 NCQ Command Error log 0x11 SL R/O 1 SATA Phy Event Counters log 0x20 SL R/O 1 Streaming performance log [OBS-8] 0x21 SL R/O 1 Write stream error log 0x22 SL R/O 1 Read stream error log 0x23 SL R/O 1 Delayed sector log [OBS-8] 0x80-0x9f SL R/W 16 Host vendor specific log 0xa0 SL VS 1 Device vendor specific log 0xa1 SL VS 20 Device vendor specific log 0xa2 SL VS 101 Device vendor specific log 0xa8 SL VS 20 Device vendor specific log 0xa9 SL VS 1 Device vendor specific log 0xe0 SL R/W 1 SCT Command/Status 0xe1 SL R/W 1 SCT Data Transfer SMART Extended Comprehensive Error Log (GP Log 0x03) not supported SMART Error Log Version: 1 ATA Error Count: 40 (device log contains only the most recent five errors) CR = Command Register [HEX] FR = Features Register [HEX] SC = Sector Count Register [HEX] SN = Sector Number Register [HEX] CL = Cylinder Low Register [HEX] CH = Cylinder High Register [HEX] DH = Device/Head Register [HEX] DC = Device Command Register [HEX] ER = Error register [HEX] ST = Status register [HEX] Powered_Up_Time is measured from power on, and printed as DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes, SS=sec, and sss=millisec. It "wraps" after 49.710 days. Error 40 occurred at disk power-on lifetime: 409 hours (17 days + 1 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 00 50 d8 cc 40 Error: UNC at LBA = 0x00ccd850 = 13424720 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- c8 00 08 4f d8 cc 40 00 00:00:49.139 READ DMA c8 00 01 80 78 01 46 00 00:00:46.796 READ DMA c8 00 01 76 16 71 42 00 00:00:45.832 READ DMA c8 00 01 00 00 00 40 00 00:00:45.817 READ DMA c8 00 01 00 00 00 40 00 00:00:53.464 READ DMA Error 39 occurred at disk power-on lifetime: 409 hours (17 days + 1 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 00 50 d8 cc 40 Error: UNC at LBA = 0x00ccd850 = 13424720 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- c8 00 08 4f d8 cc 40 00 00:00:49.139 READ DMA c8 00 01 80 78 01 46 00 00:00:46.796 READ DMA c8 00 01 76 16 71 42 00 00:00:45.832 READ DMA c8 00 01 00 00 00 40 00 00:00:45.817 READ DMA c8 00 01 00 00 00 40 00 00:00:45.817 READ DMA Error 38 occurred at disk power-on lifetime: 409 hours (17 days + 1 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 00 50 d8 cc 40 Error: UNC at LBA = 0x00ccd850 = 13424720 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- c8 00 08 4f d8 cc 40 00 00:00:42.553 READ DMA c8 00 01 80 78 01 46 00 00:00:46.796 READ DMA c8 00 01 76 16 71 42 00 00:00:45.832 READ DMA c8 00 01 00 00 00 40 00 00:00:45.817 READ DMA c8 00 01 00 00 00 40 00 00:00:45.817 READ DMA Error 37 occurred at disk power-on lifetime: 409 hours (17 days + 1 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 00 50 d8 cc 40 Error: UNC at LBA = 0x00ccd850 = 13424720 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- c8 00 08 4f d8 cc 40 00 00:00:42.553 READ DMA ca 00 08 37 57 42 42 00 00:00:42.553 WRITE DMA ca 00 08 5f 3a 42 42 00 00:00:42.540 WRITE DMA ca 00 08 97 89 03 40 00 00:00:42.540 WRITE DMA ca 00 08 47 25 03 40 00 00:00:42.514 WRITE DMA Error 36 occurred at disk power-on lifetime: 409 hours (17 days + 1 hours) When the command that caused the error occurred, the device was active or idle. After command completion occurred, registers were: ER ST SC SN CL CH DH -- -- -- -- -- -- -- 40 51 00 50 d8 cc 40 Error: UNC at LBA = 0x00ccd850 = 13424720 Commands leading to the command that caused the error were: CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name -- -- -- -- -- -- -- -- ---------------- -------------------- c8 00 08 4f d8 cc 40 00 00:00:40.003 READ DMA c8 00 08 47 d8 cc 40 00 00:00:40.003 READ DMA c8 00 08 3f d8 cc 40 00 00:00:40.003 READ DMA c8 00 08 37 d8 cc 40 00 00:00:40.003 READ DMA c8 00 08 2f d8 cc 40 00 00:00:40.003 READ DMA SMART Extended Self-test Log (GP Log 0x07) not supported SMART Self-test log structure revision number 1 Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error # 1 Short offline Completed without error 00% 1 - # 2 Short offline Completed without error 00% 1 - # 3 Short offline Completed without error 00% 1 - # 4 Short offline Completed without error 00% 1 - # 5 Short offline Completed without error 00% 1 - # 6 Short offline Completed without error 00% 1 - # 7 Short offline Completed without error 00% 0 - # 8 Short offline Completed without error 00% 0 - # 9 Short offline Completed without error 00% 0 - #10 Short offline Completed without error 00% 0 - #11 Short offline Completed without error 00% 0 - SMART Selective self-test log data structure revision number 1 SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS 1 0 0 Not_testing 2 0 0 Not_testing 3 0 0 Not_testing 4 0 0 Not_testing 5 0 0 Not_testing Selective self-test flags (0x0): After scanning selected spans, do NOT read-scan remainder of disk. If Selective self-test is pending on power-up, resume after 0 minute delay. SCT Status Version: 2 SCT Version (vendor specific): 521 (0x0209) Device State: Active (0) Current Temperature: 32 Celsius Power Cycle Min/Max Temperature: --/ 0 Celsius Lifetime Min/Max Temperature: --/ 0 Celsius SCT Data Table command not supported SCT Error Recovery Control command not supported Device Statistics (GP/SMART Log 0x04) not supported Pending Defects log (GP Log 0x0c) not supported SATA Phy Event Counters (GP Log 0x11) ID Size Value Description 0x000a 2 20 Device-to-host register FISes sent due to a COMRESET 0x0001 2 0 Command failed due to ICRC error 0x0003 2 0 R_ERR response for device-to-host data FIS 0x0004 2 0 R_ERR response for host-to-device data FIS 0x0006 2 0 R_ERR response for device-to-host non-data FIS 0x0007 2 0 R_ERR response for host-to-device non-data FIS