mirror of
https://github.com/bsdhw/SMART.git
synced 2025-05-31 16:21:41 +05:30
100 lines
5.0 KiB
Plaintext
100 lines
5.0 KiB
Plaintext
smartctl 7.2 2020-12-30 r5155 [OpenBSD 7.0 amd64] (local build)
|
|
Copyright (C) 2002-20, Bruce Allen, Christian Franke, www.smartmontools.org
|
|
|
|
=== START OF INFORMATION SECTION ===
|
|
Device Model: MK000480GWXFF
|
|
Serial Number: --
|
|
LU WWN Device Id: 5 ace42e ...
|
|
Firmware Version: HPG1
|
|
User Capacity: 480,103,981,056 bytes [480 GB]
|
|
Sector Sizes: 512 bytes logical, 4096 bytes physical
|
|
Rotation Rate: Solid State Device
|
|
Form Factor: 2.5 inches
|
|
TRIM Command: Available, deterministic, zeroed
|
|
Device is: Not in smartctl database [for details use: -P showall]
|
|
ATA Version is: ACS-4, ACS-3 T13/2161-D revision 5
|
|
SATA Version is: SATA 3.3, 6.0 Gb/s (current: 6.0 Gb/s)
|
|
Local Time is: Sun Dec 26 23:55:30 2021 MST
|
|
SMART support is: Available - device has SMART capability.
|
|
SMART support is: Enabled
|
|
|
|
=== START OF READ SMART DATA SECTION ===
|
|
SMART Status not supported: Incomplete response, ATA output registers missing
|
|
SMART overall-health self-assessment test result: PASSED
|
|
Warning: This result is based on an Attribute check.
|
|
|
|
General SMART Values:
|
|
Offline data collection status: (0x02) Offline data collection activity
|
|
was completed without error.
|
|
Auto Offline Data Collection: Disabled.
|
|
Self-test execution status: ( 0) The previous self-test routine completed
|
|
without error or no self-test has ever
|
|
been run.
|
|
Total time to complete Offline
|
|
data collection: ( 110) seconds.
|
|
Offline data collection
|
|
capabilities: (0x59) SMART execute Offline immediate.
|
|
No Auto Offline data collection support.
|
|
Suspend Offline collection upon new
|
|
command.
|
|
Offline surface scan supported.
|
|
Self-test supported.
|
|
No Conveyance Self-test supported.
|
|
Selective Self-test supported.
|
|
SMART capabilities: (0x0002) Does not save SMART data before
|
|
entering power-saving mode.
|
|
Supports SMART auto save timer.
|
|
Error logging capability: (0x01) Error logging supported.
|
|
General Purpose Logging supported.
|
|
Short self-test routine
|
|
recommended polling time: ( 2) minutes.
|
|
Extended self-test routine
|
|
recommended polling time: ( 16) minutes.
|
|
SCT capabilities: (0x0025) SCT Status supported.
|
|
SCT Data Table supported.
|
|
|
|
SMART Attributes Data Structure revision number: 0
|
|
Vendor Specific SMART Attributes with Thresholds:
|
|
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
|
|
1 Raw_Read_Error_Rate 0x000f 100 100 006 Pre-fail Always - 0
|
|
5 Reallocated_Sector_Ct 0x0033 100 100 036 Pre-fail Always - 0
|
|
9 Power_On_Hours 0x0032 099 099 000 Old_age Always - 957
|
|
11 Unknown_SSD_Attribute 0x0012 100 100 000 Old_age Always - 773
|
|
12 Power_Cycle_Count 0x0032 100 100 020 Old_age Always - 1494
|
|
171 Unknown_Attribute 0x0032 100 100 000 Old_age Always - 0
|
|
172 Unknown_Attribute 0x0032 100 100 000 Old_age Always - 0
|
|
173 Unknown_Attribute 0x0033 100 100 001 Pre-fail Always - 25700
|
|
174 Unknown_Attribute 0x0032 100 100 000 Old_age Always - 773
|
|
175 Program_Fail_Count_Chip 0x0033 100 100 050 Pre-fail Always - 0
|
|
180 Unused_Rsvd_Blk_Cnt_Tot 0x003b 100 100 006 Pre-fail Always - 0
|
|
184 End-to-End_Error 0x0032 100 100 000 Old_age Always - 0
|
|
187 Reported_Uncorrect 0x0032 100 100 000 Old_age Always - 0
|
|
188 Command_Timeout 0x0032 100 100 000 Old_age Always - 0
|
|
190 Airflow_Temperature_Cel 0x0022 064 048 000 Old_age Always - 36 (Min/Max 23/52)
|
|
194 Temperature_Celsius 0x0022 064 048 000 Old_age Always - 36 (Min/Max 23/52)
|
|
195 Hardware_ECC_Recovered 0x001a 100 100 000 Old_age Always - 0
|
|
196 Reallocated_Event_Count 0x0033 100 100 036 Pre-fail Always - 0
|
|
197 Current_Pending_Sector 0x0012 100 100 000 Old_age Always - 0
|
|
198 Offline_Uncorrectable 0x0010 100 100 000 Old_age Offline - 0
|
|
199 UDMA_CRC_Error_Count 0x003e 100 100 000 Old_age Always - 0
|
|
234 Unknown_Attribute 0x0032 100 100 000 Old_age Always - 8435
|
|
241 Total_LBAs_Written 0x0032 100 100 000 Old_age Always - 7975
|
|
|
|
SMART Error Log not supported
|
|
|
|
SMART Self-test Log not supported
|
|
|
|
SMART Selective self-test log data structure revision number 1
|
|
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
|
|
1 0 0 Not_testing
|
|
2 0 0 Not_testing
|
|
3 0 0 Not_testing
|
|
4 0 0 Not_testing
|
|
5 0 0 Not_testing
|
|
Selective self-test flags (0x0):
|
|
After scanning selected spans, do NOT read-scan remainder of disk.
|
|
If Selective self-test is pending on power-up, resume after 0 minute delay.
|
|
|
|
|
|
|